Table of Contents
Advertisement
1. Turn the filter anti-clockwise.
Fig.1
Fig.2
Page 22 of 24
Filter Replacement
2. Remove the
filter by gently
pulling down.
NOTE: For safe operation, the filter cartridge should
be replaced every 6-12 months, or earlier if you notice
a persistent reduction in water pressure from the
appliance or an unpleasant taste or odour in the water.
To Replace Filter:
• Turn the filter anti-clockwise (Fig.1) and pull the cartridge down
(Fig.2). Have an absorbent cloth ready as a small amount of
water will be released as the filter is removed. The cartridge
should release from the filter head.
•
Replace with a new filter by gently pushing up, engaging the
key and turning the filter clockwise until the filter clicks or
locks into place.
•
Perform filter flush by following the steps 1 - 4 only on pages
7-8 (Step 7 - Commissioning).
•
Go to [Replace Fitler] screen to reset the filter usage counter.
Follow the instructions on page 14 (3.4.3 Replace Filter)
section for details of menu operation.
Warning! Not changing filtration cartridges when
required may cause the water to become biologically
unsafe.
If the Zenith Autoboil is switched off for a long period of time (e.g.
more than a weekend), run water through the outlet for at least 5
minutes before consumption.
Use only Zenith Filters in this product to ensure effective filtration
and operation. Replacement filter cartridges can be obtained
through plumbing suppliers or directly from Zenith.
Filter replacement instructions are included with the filter cartridge
spare part kits.
Please dispose of the filter cartridge responsibly.
804545NZ - BW_AB Small_09.18 v1.02
Advertisement
Table of Contents
