Table of Contents
Advertisement
If required, an earth continuity test
can be performed by testing between
the earth pin on the products lead
and a exposed piece of metal on the
case and the tap body.
804545NZ - BW_AB Small_09.18 v1.02
Earthing Continuity Verification
Warning: this appliance must be earthed.
Following remedial service the earthing continuity of the heater must be
checked by a qualified technician using an appliance tester, or continuity
tester of accuracy Class 5 or better. Class 5 denotes an accuracy of 5% full
scale deflection.
1. Isolate power supply.
2. Set meter to 0 ohm with leads connected together.
3. Connect one test lead to the earth pin on the three pin plug.
4. Connect the other test lead to a bare patch of metal (preferably on the
edge) of the top of the cover, then to the front cover of the unit, and then to
the tap.
Warning- the water may be boiling - show extra care.
5. Test that in every instance the electrical resistance does not exceed 1
ohm.
Operating Procedures
Tap Operation
Boiling water
Zenith Autoboil is fitted with a two-way tap for filtered instant boiling
water.
For instant boiling water, gently pull the top of the tap forward.
Boiling water will flow until the tap handle is released.
This operation gives fingertip flow control for safe filling of cups and
mugs.
To fill larger vessels such as teapots and saucepans, rotate the tap
180 degrees and depress it until it locks into a horizontal position.
Boiling water will flow until the tap is returned to its normal vertical
position. This operation allows the vessel to be filled without
holding your hand where it may be affected by steam.
Page 21 of 24
Advertisement
Table of Contents
