Sony DSC-P30 Operating Instructions (primary manual) Operating Instructions Manual page 80

Reinstall the USB driver when using Windows 98, Windows
98SE, Windows Me and Windows 2000 Professional
Perform all steps without skipping.
1
Turn on your computer and allow Windows to load.
2
Connect the USB jack on the camera and the computer with the
supplied USB cable.
3
Insert a "Memory Stick".
4
Connect the AC power adaptor to your camera and then to a wall
outlet (mains), and turn on the power of your camera.
5
Open "Device Manager" on Windows.
For Windows 98, Windows 98SE and Windows Me users:
1
Open [Control Panel] from [
[System].
2
"System properties" is displayed. Click the [Device Manager] tab located at
the top.
3
Click [
button located at the lower-right corner.
For Windows 2000 Professional users:
* Log in with the permission of administrator.
1
Open [Control Panel] from [
[System].
2
"System properties" is displayed. Click the [Hardware] tab located at the top,
then click the [Device Manager (D)] button.
3
Click [View] in [Device Manager], then click [Devices by type (E)].
4
Right-click [
6
After the message appears to verify that you delete the device
manager, click "OK."
7
Turn off the camera, disconnect the USB cable, and restart the
computer.
8
Install the USB driver in the supplied CD-ROM to the computer
following the procedure on page 32.
80
Sony DSC] in [
Sony DSC] in [
My Computer], then double-click
Other devices], then click the [Delete (E)]
My Computer], then double-click
Other devices], then click [Delete (E)].