Gm1200E Mobile Radio Connection Information; Configuring The Rib And Gm1200E Radio - Motorola GM1200E Installation Manual

GM1200E Mobile Radio Connection Information

2.0 GM1200E Mobile Radio Connection Information
To run the Dealer Programming Software (DPS), you will need the following equipment:
1.
IBM 486 or equivalent with 16MByte RAM, Hard Disk with 10MBytes free disk space and
3.5" Floppy Disk Drive.
2.
MSDOS 5.0™, Windows 3.1™, Windows 95™ and Windows NT
3.
Radio Interface Box (RIB) RLN4008.
4.
RIB to Computer, cable 3080369B71 / 72.
5.
RIB power supply EPN4040 / EPN4041 (220 VAC) or 9V battery.
6.
Radio to RIB, Programming/Test cable GTF372 .
7.
Radio Power Supply GPN6133 or equivalent.
RIB Power Supply
EPN4040 PSU U.K. plug
EPN4041 EURO plug
2.1 Configuring the RIB and GM1200E Radio
1.
Connect the RIB to the computer (Figure 1-1) using the interface cable 3080369B71 or 3080369B72
depending on the computer connection to Serial COM Port 1. If you are unsure of the connection on the
back of your computer or the COM port, then please consult the computer manuals.
2.
Plug the 25 pin end of the Radio programming cable, GTF372 into the RIB. Then plug the other end into
the MIC connector on the radio.
3.
Connect the RIB Power supply to the RIB and plug the other end into a wall outlet, (alternatively a 9V
battery may be used instead of the power supply).
4.
Connect the radio to a power source and press the On/Off button to turn the radio on.
1-2
RIB to Computer Cable.
Plugs into RIB and computer.
3080369B71 Interface cable IBM XT 25pin
3080369B72 Interface cable IBM AT 9pin
15 PIN
RLN4008
Radio
Interface
Box
25 PIN
GTF372
Std programming cable.
Plugs between the RIB and
radio MIC connector.
GPN6133
Power Supply
or equivalent
Figure 1-1
GM1200E Radio Programming Setup.
TM
.
Computer
Software
GM1200E
Mobile Radio
HKN4191
DC cable for base
operation or equivalent.
DPS Installation
User Manual