Sony Ericsson K530c Manual page 7

Using the USB charger
To connect the charger and charge
the battery
1 Connect the USB cable plug to the AC
adapter USB socket, as shown in the
above illustration. The USB cable is
supplied with your phone.
2 Connect the USB cable connector to
your phone. Press a key to view the
charging status on the screen. It takes
approximately XXX hours to fully charge
the battery.
To remove the charger
1 Charge your battery until the battery
icon indicates a full charge.
2 Tilt the USB charger connector upwards
to remove it.
Note:
1 The USB cable for the new USB
charger shown in the illustration (Part.
B in the new-type charger illustration)
on page XX is only intended for
2.5 h
charging your phone. Do not use it
for transferring data.
2 The USB cable for the USB charger
shown in the illustration (Part. B in the
new-type charger illustration) is only
intended for connection to the AC
adapter (Part. A in the new-type
charger illustration) to charge your
phone. It must not be used for
connection to a PC. It can only be
used for charging your phone. Never
use it for charging accessories.
3 Sony Ericsson strongly recommends
that you use only Sony Ericsson
branded original batteries, the part of
power supply device in accordance
with YD/T 1591-2006 specifications
of Communications Industry Standards
of P. R. China (Part A in the new-type
charger illustration) and the USB
cable supplied with your phone to
charge the phone. The use of third-
party products may decrease the
performance of your phone and/or
pose a risk to your health or safety.
Getting started 5