Toshiba TOSVERT VF-AS3 Instruction Manual page 66

Instanc Attribute Access Name
e ID
5 Get
1 or 2
7 Get
10 Get
11 Get
Note: Don't use the "System reserved" bit and Bit0 for the judgement.
Instance Services
Service Code Service Name
0x01 Get_Attribute_All
0x0E Get_Attribute_Single
0x10 Set_Attribute_Single
0x4C Get_and_Clear
Data
type
Media Counters STRUCT
of
Alignment Errors UDINT
FCS Errors UDINT
Single Collisions UDINT
Multiple Collisions UDINT
SQE Test Errors UDINT
Deferred UDINT
Transmissions
Late Collisions UDINT
Excessive Collisions UDINT
MAC Transmit UDINT
Errors
Carrier Sense Errors UDINT
Frame Too Long UDINT
MAC Receive Errors UDINT
Interface Type USINT
Interface Label SHORT_
STRING
Interface Capability STRUCT
of
Capability Bits DWORD
Speed/Duplex STRUCT
Options of
Speed/Duplex Array USINT
Count
Speed/Duplex Array Array of
Struct of
Interface Speed UINT
Interface Duplex USINT
Mode
Read all attributes
Read one attribute
Write one attribute
Gets then clears the specified attribute
(Interface Counters or Media Counters).
64
Details
Media-specific counters
Frames received that are not an integral
number of octets in length
Frames received that do not pass the FCS
check
Successfully transmitted frames which
experienced exactly one collision
Successfully transmitted frames which
experienced more than one collision
Number of times SQE test error message is
generated
Frames for which first transmission attempt
is delayed because the medium is busy
Number of times a collision is detected
later than 512 bit times into the
transmission of a packet
Frames for which transmission fails due to
excessive collisions
Frames for which transmission fails due to
an internal MAC sublayer transmit error
Times that the carrier sense condition was
lost or never asserted when attempting to
transmit a frame
Frames received that exceed the maximum
permitted frame size
Frames for which reception on an interface
fails due to an internal MAC sublayer
receive error
Type of interface
2: twisted pair
Human readable identification
Instance 1: 9, "Left port"
Instance 2: 10, "Right port"
Indication of capabilities of the interface.
Interface capabilities, other than
speed/duplex.
Indicates speed/duplex pairs supported in
the Interface Control attribute.
Number of elements.
Speed in Mbps
0=Half duplex
1=Full duplex
Description of Service
E6582125