Bosch GSB18V-535C Operating And Safety Instructions Manual page 9

2610045250.qxp_GSB18V-535C 6/20/18 10:26 AM Page 9
Disconnect battery pack from tool before making any assembly, adjustments
or changing accessories. Such preventive safety measures reduce the risk of
starting the tool accidentally.
INSERTING AND RELEASING
BATTERY PACK
Set Forward/Reversing lever to the center (off
position). Slide charged battery pack into the
housing until the battery pack locks into position
(Fig. 2).
Your tool is equipped with a secondary locking
latch to prevent the battery pack from completely
FIG. 2
BATTERY PACK
INSERTING BITS
Move reverse switch lever to the center "OFF"
position. Remove battery pack and rotate the
clutch ring (Model GSR18V-535C) or mode
selctor ring (Model GSB18V-535C) to the drill bit
symbol " ". To open rotate the chuck
sleeve counter-clockwise viewing from chuck end,
and open chuck to approximate drill bit diameter.
Insert a clean bit up to the drill bit flutes for small
bits, or as far as it will go for large bits. Close
chuck by rotating the chuck sleeve clockwise and
securely tighten by hand (Fig. 4). Return the
clutch ring or mode selector ring to desired
position.
Assembly
falling out of the handle, should it become loose
due to vibration.
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward (Fig. 3).
Press the battery pack release button again and
slide the battery pack completely out of tool
housing (Fig. 3).
FIG. 3
BATTERY PACK
RELEASE BUTTON
loosen or tighten bit. Friction burn or hand injury
is possible if attempting to grasp the spinning
chuck.
FIG. 4
DRILL BIT
SAVE THESE INSTRUCTIONS
Do not use the power of the
drill while grasping chuck to
CHUCK CLOSE
SLEEVE
OPEN
BIT HOLDER
SCREWDRIVER BIT
9