Using Basic Functions Setting Up The Tv Automatically - Sony WEGA KV 27FV300 Operating Instructions Manual

Using Basic Functions
Setting Up the TV Automatically
After you have finished connecting your TV, you can perform Auto Program to set up your
channels. When Auto Programming, the TV will automatically search for available channels
and program receivable channels.
The direction in this manual will refer to the remote control that incorporates a joystick (RM-Y182).
See "Using the Remote Control" on page 3 for further details on this remote.
1
Press to turn on the TV. The Initial Setup screen appears.
2
Press on the remote control or on the TV front panel to perform Auto Program, or
press to exit.
The Initial Setup screen appears each time you turn on the TV until you perform Auto Program.
To perform Auto Program again
1
Press .
2
Use the joystick to highlight Channel Setup Menu.
3
Use the joystick to scroll down to highlight Cable. Press
4
Use the joystick to scroll up and down select On or Off according to how you connected
your TV. Press
5
Use the joystick to highlight Auto Program. Press
6
After performing Auto Program, press
To reset the TV to factory settings
1
Turn the TV on.
2
Hold down on the remote control.
3
Press and release the POWER button on the TV front panel. (The TV will turn itself off,
then back on.)
4
Release .
Initial Setup
Auto Program: [CH+]
Exit:
First please connect
cable/antenna
.
[CH–]
to select.
to search for channels.
to exit.
21