Faults - Kärcher HDS 995 MX Eco Manual

English
Clean strainer in water
connection
Fig. 11
! Remove strainer
! Clean in water and re-insert
Clean the fine filter
Fig. 12
! Cut pressure to unit
! Screw off cover with filter
! Clean filter with clean water or with
compressed air
! Assemble in the reverse order
Clean strainer in low water
protection
Fig. 13
! Unfasten union nut and detach hose
Fig. 14
! Take out strainer
If necessary, screw-in screw M8 by
approx. 5 mm and pull out the strainer with
this screw
! Clean strainer in water
! Slide in strainer
! Mount hose
! Tighten union nut
Clean filter at cleaning-agent
suction hose
Fig. 15
! Pull the cleaning agent suction inlet pipe
out
! Clean filter in water and re-insert
32
Operating Instructions
Change oil
Fig. 16
! Provide a collecting container for
approx. 1 litres of oil
! Unscrew drain plug
Dispose of used oil ecologically or hand it
in at a dump.
! Retighten drain plug
! Top up oil slowly up to the MAX mark
Air bubbles must be able to escape
Refer to technical data for oil grade and
quantity to be used.

Faults

Engine/electronics indicator lamp
(item 28) flashes
— This warning lamp flashes if there is a
problem.
! When you open the cover (item 8) of the
compartment (item 6) the electronic
display is visible in the window (item 4).
! The warning lamp goes out when the
problem has been resolved and the unit
is switched on again.
Display
Troubleshooting
! Increase the water inlet volume
! Clean strainer in water connection
! Clean the strainer (coarse) fitted in front
of the low water protection