Siemens Simatic S7-200 CPU 210 System Manual page 57

Refer to Figure 3-17 and follow these steps to enter the output coil that ends the first rung of
the first network:
1. Select "Output Coils" from the family listing and select "Set" from the instruction listing.
2. Type either the symbolic name Alarm_Bit or the absolute address M0.1 in the
highlighted area.
3. Pressing ENTER highlights the "number of points" field (located underneath the output
coil). Press ENTER to accept the default value of 1. (The CPU 210 allows only one point
to be set or reset by any one Set or Reset instruction.)
4. Move the cursor to the position below the first contact.
Output Coils
Network 1
"Panic_Alarm"
Select "Output Coils"
from the family listing.
Output Coils
Network 1
"Panic_Alarm"
Output Coils
Network 1
"Panic_Alarm"
Figure 3-17 Entering the Output Coil
S7-200 Programmable Controller, CPU 210
C79000-G7076-C235-01
Getting Started with a Sample Program
Set
F2
Output
Set
Sound the alarm!
Reset
Set
F2
Sound the alarm!
Q0.0
S
1
Set
F2
Sound the alarm!
"Alarm_Bit"
S
1
Position the cursor
below the first contact.
F3
F4 F5 F6 F7 F8
Select "Set" from the
instruction listing.
F3
F4 F5 F6 F7 F8
Enter the address:
M0.1
or
Alarm_Bit
F3
F4 F5 F6 F7 F8
F10
F10
F10
3-17