Configuring The Industrypacks - Motorola MVME162LX 300 Series Installation And Use Manual

Set Environment to Bug/Operating System
A

Configuring the IndustryPacks

A-16
asks the following series of questions to set up IndustryPacks (IPs)
ENV
on MVME162LX Embedded Controllers.
The MVME162LX Embedded Controller Programmer's Reference Guide
describes the base addresses and the IP register settings. Refer to that
manual for information on setting base addresses and register bits.
Note
The IPIC chip on the MVME162LX Embedded
Controller supports up to four IndustryPack interfaces,
designated IP_a through IP_d. The controller itself
accommodates two IPs: IP_a and IP_b. In the following
discussion, the segments applicable to IP_c and IP_d are
not used in the controller.
IP A Base Address
IP B Base Address
IP C Base Address
IP D Base Address
Base address for mapping IP modules. Only the upper 16 bits are
significant.
IP D/C/B/A Memory Size
Define the memory size requirements for the IP modules:
Bits IP
31-24
23-16
15-08
07-00
= 00000000?
= 00000000?
= 00000000?
= 00000000?
= 00000000?
Register Address
D FFFBC00F
C FFFBC00E
B FFFBC00D
A FFFBC00C
Computer Group Literature Center Web Site