Bose T5 Service Manual page 16

DISASSEMBLY PROCEDURES
Yoke pin
Cable on outer side
2.4 Align and press the replacement ear
cushion onto the earcup assembly until it
snaps into place. Ensure it is fully seated.
3. Nape Band Replacement
3.1 Remove nape band cover
3.2 Press upward on nape band yoke until
the yoke pin clears the earcup. Disengage
the lower yoke pin from the earcup. Perform
this step on the other earcup.
3.3 Insert the replacement nape band upper
yoke pin into the earcup upper pin hole.
Press downward on the yoke and engage
the lower yoke pin in the earcup lower pin
hole.
3.4 Replace the nape band cover. Only the
middle portion secures the earcup wire to
the nape band.
Note: The cable running between the
earcups should be on the outer side of the
yoke. Remove and reuse serial number
label on replacement nape band. Attach
new product label to nape band.
4. Earcup Assembly Replacement
Note: The earcup assembly includes both
earcups, the nape band w/cover and the
head strap.
4.1 Remove the two captive screws that
secure the control module cable / boom
microphone to the bottom of the left earcup.
4.2 Gently pull the control module cable /
16