Table of Contents
Advertisement
DR (Disaster Recovery
To enable DR Mode, set position 1 [Drive Mode] switch to ON.
ON
OFF
1
2
*
In Disaster Recovery Mode, an SDX-900V series drive enters the DR
Standby Mode 15 seconds after you insert a write-protected tape into the
drive, and all the drive LED blink. If you restart the drive while the LED
are blinking, it starts as a CD-ROM device.
For details about the Disaster Recovery Mode, refer to the instruction
manual that came with the application software you are using.
Emulation Mode
To enable Emulation Mode, set the position 2 [Drive Mode] switch to ON.
ON
OFF
1
2
*
Emulation Mode returns the following in the Product Identification field
of Inquiry of a SDX-900V series drive.
Data Compression Control DIP switch
Data compression can be selected by DIP switches. Data compression is
enabled while position 7 [DC Control (1)] is ON. Control by host can be
disabled when position 8 [DC Control (2)] is ON.
12
*
) Mode
3
4
5
6
*
3
4
5
6
SDX-700C
1 DR (Disaster Recovery) Mode (ON)
2 Emulation Mode
3 AIT Library Interface Mode
4 Reserved
5 Terminator Power
6 Periodic Cleaning Req
7
8
7 DC Control (1)
8 DC Control (2)
1 DR (Disaster Recovery) Mode
2 Emulation Mode (ON)
3 AIT Library Interface Mode
4 Reserved
5 Terminator Power
6 Periodic Cleaning Req
7
8
7 DC Control (1)
8 DC Control (2)
Advertisement
Table of Contents
