Auto Pairing; Bluetooth - Mobile Phone; Receive A Call - JVC KD-X462BT Instruction Manual

BLUETOOTH®
"PAIRING COMPLETED" appears when pairing is completed and "O" will
light up when the Bluetooth connection is established. For KD-X462BT, the
battery and signal strength of the connected Bluetooth device is shown (see
[FORMAT] on page 27).
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device, see
[DEVICE DELETE] on page 17.
• A maximum of two Bluetooth phones and one Bluetooth audio device can
be connected at any time.
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. (Page 19)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• When the battery of the connected Bluetooth device runs low, "Device
Name" "LOW BATTERY" appears.
• Refer to the instruction manual of the Bluetooth device for more
information.

Auto Pairing

When you connect iPhone/iPod touch to the USB input terminal, pairing
request (via Bluetooth) is automatically activated.
Press the following to pair once you have confirmed the device name.
KD-X462BT: Volume knob
KD-X368BT: * ENTER
Automatic pairing request is activated only if:
– Bluetooth function of the connected device is turned on.
– [AUTO PAIRING] is set to [ON]. (Page 18)
14
ENGLISH
BLUETOOTH — Mobile phone
For key layout on the faceplate, see page 3 or page 4.

Receive a call

When there is an incoming call:
• The buttons or symbolic button will blink in the color you have selected in
[RING COLOR]. (Page 16)
• The unit answers the call automatically if [AUTO ANSWER] is set to a selected
time. (Page 16)
During a call:
• The buttons or symbolic button stop blinking and illuminate in the color
you have selected in [RING COLOR]. (Page 16)
• If you turn off the unit or detach the faceplate, Bluetooth is disconnected.
The following operations may differ or be unavailable depending on the
connected phone.
To On the faceplate
First incoming call...
Answer a call
Press
button.
KD-X462BT: Volume knob
KD-X368BT: * ENTER
Reject a call
Press and hold
following button.
KD-X462BT: Volume knob
KD-X368BT: * ENTER
End a call
Press and hold
following button.
KD-X462BT: Volume knob
KD-X368BT: * ENTER
On the remote control
Press J / K / H / I.
or the following
Press and hold
or the
J / K / H / I.
Press and hold
or the
J / K / H / I.