General Information; Product Information; Burner Specifications - Trane Gas Heat Sections for Performance Climate Changer Air Handlers Installation, Operation And Maintenance Manual

General Information

Product Information

Model and serial numbers for the gas heat section are designated on the nameplate located on the
piping-side access door inside the section. Record the information below for a permanent record
of the equipment installed on your job site. The nameplate also contains the range of settings for
which the gas heat unit is capable. Record and retain these settings in case the unit should ever
need adjustment after service repairs.
Note: This information is required when ordering repair parts.
Model Number____________________________________________________________________________
Serial Number_____________________________________________________________________________
Air Handler Sales Order Number____________________________________________________________
Air Handler Serial Number_________________________________________________________________
Startup Date_______________________________________________________________________________
Altitude Above Sea Level___________________________________________________________________
Calorific Value_____________________________________________________________________________

Burner Specifications

Maximum Firing MBh______________________________________________________________________
Minimum Firing MBh______________________________________________________________________
Type of Gas________________________________________________________________________________
Maximum Inlet Gas Pressure_______________________________________________________________
Minimum Inlet Gas Pressure________________________________________________________________
Temperature Rise (ºF)_______________________________________________________________________
Manifold Pressure at Maximum MBh________________________________________________________
Table 1. Motor and Electrical Specifications
Specifications Gas Heater Input Power
Volts
Hertz
Phase
HP
FLA/Amps
MCA
MOP
1
Powered by a "line to 115 volt" transformer for all gas heaters except 115/60/1 rated units.
Note:
CLCH-SVX08A-EN
Burner Motor
115
60 60
n/a
n/a
n/a
n/a
1
Control Power
115
60
1 1
n/a
6
n/a
n/a
1
Exhaust Motor
60
n/a
n/a
7