Yamaha Clavinova CVP-205 Service Manual page 21

CVP-205/CVP-205M
Spring
27 Assembling the Keyboard
(Time required: About 15 minutes)
27-1 Hammer, White Key (Hammer, Black Key)
Place the keyboard assembly upside-down, insert a hammer
assembly into the frame, and put the stopper (L88_W) on.
(Fig. 35)
* There are four (4) kinds of hammers that differ in weight.
27-2 Spring
Place the GH-Dcl keyboard assembly rightside up. Fix
key springs on the frame by setting one at each slit and
pushing down once on each key spring. (Fig. 36)
* Be careful of the direction of the spring.
White Key (Black Key)
27-3
After a key has been fit to part [C] and key guide, make
sure that the spring is fixed to the key and then press down
part [B] of the key. (Fig. 37)
27-4 GH-DclSW L Circuit Board
Tighten the seven (7) screws marked [260A] to fix the
GH-DclSW L circuit board. (Fig. 30)
GH-D SW H Circuit Board
27-5
Tighten the ten (10) screws marked [260B] to fix the GH-
D SW H circuit board. (Fig. 30)
* Install the circuit boards in the keyboard assembly so that
the hooks hold it as shown in figure 38.
21
Thin metal plate etc
Triangle mark
Fig. 31
Hook
Fig. 33
White key
[A]
Fig. 32
Hammer, white key
Stopper (L88_W)
Fig. 34
Spring
Round stick
(Rod: TX000670)