Analog Output Modules - Honeywell CentraLine CLIOL822A Product Data

LONWORKS BUS I/O MODULES – PRODUCT DATA

Analog Output Modules

1
2
Fig. 10. CLIOPR822A LonWorks Bus AO Module (shown
with terminal socket)
Legend
1 L W service button S1
ON ORKS
2 Manual overrides
3 Status LEDs
4 Service LED
5 Power LED
NOTE: The hex switch S2 (located next to the L
service S1) has no function in combination with a
L W Bus I/O module. It is used with Panel
ON ORKS
Bus I/O modules, only.
The CentraLine L W
ON ORKS
8 analog outputs, are available in the following models:

CLIOL822A L W Bus Analog Output Module
ON ORKS
(without manual overrides)

CLIOLR822A L W
ON ORKS
manual overrides)
EN0Z-0980GE51 R0119
3 4 5
W
ON ORKS
Bus Analog Output Modules, with
Bus Analog Output Module (with
They are installed with the XS821-22 or XSU821-22 Terminal
Socket.
COM
71
A
COM
72
B
24
73
V~
24
74
V~0
NC NC
AO1 AO2 AO3 AO4 AO5 AO6 AO7 AO8
21 22 1 2 3
GND GND GND GND GND GND GND GND GND GND
9 10 11 12 13
Fig. 11. CentraLine L
Modules (schematic)
Features

0...11 VDC, +/-1 mA

Floating actuator (requires MCD3)

Binary output (0 V / 10 V)

red LED per output (brightness according to signal level)

Optional versions with manual override potentiometers
(Auto, 0...100%; LED flashes in override mode)

Feedback on manual override signal

8-bit resolution

Configurable safety position for outputs in case of
communication problems (remain, 0%, 50%, 100%)
8
COM
A
COM
B
24
V~
24
V~0
4 5 6 7 8
14 15 16 17 18 25 26
W Bus Analog Output
ON ORKS
75
76
77
78