Aiwa NSX-MT960 Operating Instructions Manual page 28

5.1 CH INPUT
jacks of this unit support the DOLBY DIGITAL
SURROUND system.
Connect a DVD player with 5.1 CH output jacks to this unit using
cables with RCA phono plugs as follows:
DVD player's jack This unit's jack
5.ICH OUTPUT FRONT (L, R), etc. 5.ICH FRONT (L, R)
5.ICH OUTPUT REAR (L, R), etc.
5.1 CH REAR (L, R)
5.1 CH OUTPUT CENTER, etc. 5.1 CH CENTER
5.1 CH OUTPUT SUB WOOFER, etc. 5.1 CH WOOFER
LINE OUT (L, R), etc VIDEO/AUX
(See -.)
/'7 /
VIDEOI
AUX IN
LI
n -
mm
T
m
If the DVD is not connected to Vi DEO/AUX IN jack of this unit,
the sound from the connected DVD player cannot be recorded.
To remove this limitation, connect the LINE OUT jacks of the
DVD player to VIDEO/AUX IN jacks of this unit besides
conencting to 5.1 CH INPUT jacks. The signals through VIDEO/
AUX IN jacks enable the recording to be done. Refer also to
the operating instructions of the DVD player.
DOLBY DIGITAL SURROUND sound cannot be recorded in
any way.
VIDEOI
AUX
MANUAL
SELECT (TEST)
VIDEOIAUX
M DOWN,
w UP
When a DVD player is connected to the 5.1 CH INPUT jacks of
this unit, you can listen to DOLBY DIGITAL SURROUND sound,
which enables you to enjoy theater-quality sound in your home.
7 Press VIDEO/AUX repeatedly until "5.1 ch IN" is
displayed.
2
Start playing DOLBY DIGITAL SURROUND sound
on the DVD player.
m
The DOLBY PRO LOGIC, BBE and the SURROUND are
automatically canceled when the 5.1 CH is selected.
Make sure the software played back with the connected DVD
player support the DOLBY DIGITAL SURROUND.
The function is changed from the 5.1 CH to the VIDEO when:
- the headphones are plugged in.
- the MIC or ECHO level is changed.
- the Rhythm play function, the SURROUND system, the
DOLBY PRO LOGIC or the Karaoke function is turned on.
To adjust the sound levels of the center and surround
speakers in DOLBY DIGITAL SURROUND
Use the remote control.
1
2
3
Press VIDEO/AUX repeatedly until "5.1 ch IN" is displayed.
Press MANUAL SELECT (TEST) repeatedly.
Speaker names appear in turn as follows:
r
L/R (Speaker balance) _ CEN: Center speaker
S-R: Surroundspeaker _
S-L: Surround speaker J
(Right) (Left)
Press - DOWN or ~ UP to adjust the sound level while
"CEN", "S-L" or "S-R is displayed.
Each level can be adjusted between -8dB and +7dB.
Repeat steps 2 and 3 to adjust each speaker's surround level.
If the surround speakers or the center speaker level of the DOLBY
DIGITAL SURROUND is changed, that of the SURROUND
system (page 9) and the DOLBY PRO LOGIC (page 20) are
also changed.
27
ENGLISH