Table of Contents
Advertisement
SERVICE PROCEDURE RG-X
Diptube and Anode
Inspection and Replacement
ANODE INSPECTION AND REPLACEMENT
Heater components and stored water may be HOT when performing the following steps in
this procedure. Take necessary precaution to prevent personal injury.
Step 1.
Turn off water supply to water heater. Rotate knob of combination thermostat/gas valve to
"OFF" position.
Step 2.
Turn off cold water supply to heater. Connect hose to drain spigot of water heater and route to an
open drain. Open a nearby hot water faucet to vent heater for draining. Open drain spigot of
water heater and allow heater to drain to a point below the outlet connection nipple.
Step 3.
Disconnect outlet nipple from plumbing system.
Step 4
With an appropriate wrench, remove outlet nipple/anode from the water heater. Use caution not to
damage pipe threads.
Step 5.
Visually Inspect outlet nipple/anode. Outlet nipple/anode should show signs of depletion, this is
normal. If depletion is ½ of the original anode diameter (approximately 5/8" diameter), replacement
is recommended. If any of the steel core of the anode is exposed, replacement is recommended.
Step 6.
Upon completion of inspection or subsequent replacement, reinstall outlet nipple/anode into heater.
Ensure pipe dope is used on the nipple's threads. Connect nipple to plumbing system, resume
water supply and refill heater with water.
Step 7.
To resume operation, follow the instructions located on the lighting instruction label or the lighting
instructions located in the installation and operation manual.
SERVICE PROCEDURE RG-X
Inspection and Replacement
ANODE INSPECTION AND REPLACEMENT
WARNING
Heater components and stored water may be HO
Step 1.
Turn off water supply to water heater. Rotate knob o
"OFF" position.
Step 2.
Turn off cold water supply to heater. Connect hose
open drain. Open a nearby hot water faucet to vent
water heater and allow heater to drain to a point bel
Step 3.
Disconnect outlet nipple from plumbing system.
Step 4
With an appropriate wrench, remove outlet nipple/an
damage pipe threads.
Step 5.
Visually Inspect outlet nipple/anode. Outlet nipple/an
normal. If depletion is ½ of the original anode diame
is recommended. If any of the steel core of the anod
Step 6.
Upon completion of inspection or subsequent repla
Ensure pipe dope is used on the nipple's thread
water supply and refill heater with water.
Step 7.
To resume operation, follow the instructions located
instructions located in the installation and operation
Diptube and Anode
this procedure. Take necessary preca
WARNIN
35
35
Hide quick links:
Advertisement
Table of Contents
