Description - Siemens SINUMERIK 840 sl Manual

Power supply connector for MCP 398C
Connection type
Connection screw
Operating tool
Specified tightening torque
Conductor cross-section min./max.
Solid
Finely stranded
With ferrule with collar DIN46228/4
With ferrule DIN46228/1
AWG cables, solid or stranded
2.3.2

Description

Switch S1
MCP set up as PN
Table 2-3
See Table "Settings of switch S1"
The two switches S1-9 and S1-10 must be set to "on" for the PN functionality.
The switches S1-1 to S1-8 define the default device name.
Up to 128 default device names are possible. If these default device names are used, there is
no need for initialization of the MCP.
Note
Reconfiguration of preset device names not possible
You cannot reconfigure preset device names, for example, with STEP 7 "Device initialization".
Note
SINUMERIK control must support the PN functionality of the MCP
When you connect the MCP to a SINUMERIK control as a PROFINET component, make sure
that this functionality is supported by the relevant control.
DCP mode:
No default device name is available in this mode. You must set the device name by means of
Machine control panel: MCP 398C
Manual, 07/2018, A5E43199783B AB
General switch S1 setting
1-8
Strain-relief clamp connection
M2.5 screw with cross-slot
Screwdriver blade 0.6x3.5, PH0, PZ0 (DIN
5264, ISO 8764/2-PH, ISO 8764/2-PZ)
Nm 0.4 ... 0.5
mm² 1.3 ... 3.3
mm² 1.3 ... 3.3
mm² 1.3 ... 2.5
mm² 1.3 ... 3.3
AWG 12 ... 16
9 10 Meaning
on on PN
off off IE (default)
Description
2.3 Interfaces
17