Messages - Sony Walkman MZ-R900DPC Operating Instructions Manual

Messages

If the following error messages flash in the display window, check the chart below.
Error message
BLANKDISC
DISC ERR
DISC FULL
Data Save
TOC Edit
BUSY
NAME FULL
Hi DC in
HOLD
LOW BATT
MEM OVER
Meaning/Remedy
• An MD with no recording on it is inserted.
• The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. If this fails, rerecord.
• There is no more space to record on the disc.
, Replace the disc.
• The MD player is recording information (sounds) from the
memory to the disc.
, Wait until this process is completed. Do not expose the player
to any physical shock, nor disrupt power supply.
• The MD player is recording information (track start and end
position) from the memory to the disk.
, Wait until this process is completed. Do not expose the player
to physical shock, nor disrupt power supply.
• You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take a few
minutes).
• You tried to enter more than 200 letters to label a single track or
disc.
• You tried to enter a total of more than 1700 letters for track or disc
names.
, Enter the characters within the limit.
• Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car
battery cord.
• The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder
(page 55).
• Batteries are weak.
, Charge the rechargeable battery or replace the dry battery
(page 57).
• You tried to record with the recorder placed where it receives
continuous vibration.
, Put the recorder on a stable place, and start recording again.
65
-GB