On The Remote Control - Sony Walkman MZ-R900DPC Operating Instructions Manual

3
Flip the jog lever (L) until the phrase
you want to erase appears, and then
press the lever (L).
" Erase!" appears and the phrase is
erased. If no phrase is stored in the
phrase bank, " EMPTY" appears in
the display.
To cancel the operation, press x.

On the remote control

DISPLAY
Control
Storing phrases while labeling
1
Do the procedure " On the remote
control" in " Labeling recordings"
(page 48) to enter a phrase.
2
After entering the phrase, press X for
2 seconds or more.
" Entry!" appears in the display and
the cursor flashes after the phrase you
just stored. You can then continue
with labeling operation.
z
You can store phrases from a previously labeled
track or disc.
Do the procedure " Relabeling recordings"
(page 49) and display the track or disc name
that contains the phrase that you want to store.
Press VOL +/– repeatedly to move the cursor to
the right of the phrase. Then press X for 2
seconds or more to store the phrase.
X
x
Storing phrases using the EDIT
menu
1
Press DISPLAY for 2 seconds or
more.
2
Turn the control towards . or
towards N> until " EDIT" flashes
in the display, and press x.
3
Turn the control towards . or
towards N> repeatedly until
" Name Bank" flashes in the display,
and then press x.
4
Enter the phrase you want to store,
then press x for 2 seconds or more.
" Entry!" appears in the display and
the phrase is stored.
Retrieving phrases stored in
the phrase bank
Searching for a phrase by displaying
the stored phrase one by one
1
Do the procedure " On the remote
control" in " Labeling recordings"
(page 48) until "
" : Name" appears in the display.
Then press x.
2
Press X repeatedly until the first
phrase stored in the phrase bank
appears in the display.
3
Turn the control towards . or
towards N> repeatedly.
Turning the control towards . or
towards N> causes the phrases
stored in the phrase bank to appear
one by one. If you press X at this
time, the first phrase stored in the
phrase bank retrieved.
4
Press x while the phrase you want is
shown in the display.
The cursor flashes after the phrase
you just retrieved. You can then
continue with labeling operation.
: Name" or
51
-GB