Mitsubishi MELSEC L Series User Manual page 103

(6) Set value change completed flag (XC)
When adjusting the offset/gain setting, Set value change completed flag (XC) is used as an interlock condition to
turn Set value change request (YC) OFF → ON → OFF.
For the offset/gain setting, refer to the following.
• Offset/gain setting (
Set value change completed flag (XC)
Set value change request (YC)
(7) Warning output signal (XE)
In D/A conversion enabled channels, if any digital value exceeds the alarm output upper limit value or is below
than the alarm output lower limit value, Warning output signal (XE) turns ON.
Latest error code (Un\G19)
Warning output signal (XE)
Warning output clear request (YE)
(a) Turning OFF Warning output signal (XE)
Turn OFF by the following two methods.
• Turning OFF → ON → OFF Warning output clear request (YE)
• Turning OFF → ON → OFF Operating condition setting request (Y9)
When alarm code is stored in Latest error code (Un\G19), Warning output signal (XE) is cleared to 0.
(8) Error flag (XF)
Error flag (XF) turns ON if an error occurs.
Latest error code (Un\G19)
Error flag (XF)
Error clear request (YF)
(a) Turning OFF Error flag (XF)
Eliminate the error cause, and turn OFF → ON → OFF Error clear request (YF).
(At the timing of turning Error clear request (YF) from OFF to ON, Error flag (XF) and Latest error code
(Un\G19) are cleared.)
Page 125, Appendix 8.1)
Controlled by the D/A converter module
Controlled by the program
ON
ON
Controlled by the D/A converter module
Controlled by the program
0
Warning
ON
Controlled by the D/A converter module
Controlled by the program
0
ON
OFF
OFF
0
OFF
ON
OFF
0
Error
OFF
ON
OFF
APPENDICES
APPEN
DIX
101