Message
LINE OUT
NO VOL OPERATION
LOW BATTERY
MEMORY OVER
NO
BookmarkedTRACK
NO DIGITAL COPY
NO DISC
NO GROUP
NO INPUT SIGNAL
NON GROUPED TRACK
NO TRACK
P/B ONLY DISC
PC--MD
PLAY MODE
PROTECTED DISC
PUSH STOP BUTTON
READ ERROR
REC ERROR
Case and/or corrective action
You tried to change the volume while "Audio Out" in the menu has been set
to "Line Out". Set "Audio Out" to "Headphone" ( page 59).
The rechargeable battery is weak. Charge the rechargeable battery ( page
14).
You tried to record with the recorder placed where it receives continuous
vibration. Put the recorder on a stable place, and start recording again.
You selected bookmark play without setting bookmarks. Set bookmarks
( page 43).
You tried to make a copy from a disc that is protected by the Serial Copy
Management System. Make analog recording ( page 38).
You tried to play or record with no disc in the recorder. Insert a disc.
You selected "Group Erase" or "Group Move" in the menu on the recorder,
or "Title" – "Group" in the menu on the remote while using a disc with no
groups.
The recorder could not detect digital input signals. Make sure that the
source is connected firmly ( page 37). If you are making an analog
recording, ignore the message.
You selected "Group Erase" or "Group Move" in the menu on the recorder,
or "Title" – "Group" in the menu on the remote while selecting a track that
does not belong to a group.
You tried to play a disc used in Hi-MD mode with no recorded tracks.
You tried to record or edit on a premastered disc (P/B stands for
"playback"). Insert a recordable disc.
You operated the recorder or the remote while the recorder is connected to
the computer. Disconnect the recorder from the computer ( page 22).
You operated the recorder while selecting the playback mode on the
remote.
You tried to record or edit on a disc with the tab in the record-protect
position. Slide the tab back ( page 76).
You tried to open the lid while the recorder was storing disc information
with the recorder connected to a computer. Wait until "SystemFILE
WRITING" has disappeared from the display after pressing · CANCEL.
The recorder cannot read the disc information correctly. Reinsert the disc.
Recording was not correctly done. Place the recorder at a place with no
vibrations and record again.
The disc is soiled with an oil film or finger prints, is scratched, or is not a
standard disc. Try recording again with another disc.
73