Looper Threading Tool - Baby Lock Celebrate BLS1 Instruction And Reference Manual

U

Looper Threading Tool

S
I
N
G
S
P
E
C
I
A
L
T
Y
T
H
R
E
A
D
S
39
1. Open the front cover and raise the presser foot.
A
2. At the threading port, cut the looper thread that is to be
replaced. Remove thread from under the foot and the
upper thread guides. Replace cone of thread with
specialty thread.
3. With machine in locked position, set the looper threading
port to U or L, according to the looper that is being
threaded.
4. Thread specialty thread into the upper thread guides,
leaving an 18-inch (40cm) tail above the threading port.
5. Place the straight end of the looper threading tool into the
threading port. Push the looper threading tool until the
end comes out of the looper eye.
B
6. Insert the specialty thread tail into the looper threading
tool eye. (fig. A) Pull the straight end of the looper
threading tool through the looper eye bringing the
specialty thread with it. (fig. B)