Philips 32PFL5405H/05 Service Manual page 15

4.4 Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.5 Assy/Panel Removal Rembrandt Styling
The instructions apply to the 42PFL5405H/xx.
4.5.1 Rear Cover
With the Rembrandt styling, a new concept of housing has
been introduced, having consequences for Service when
opening the set.
Part of the "back cover" now forms one assy with the LCD panel
and will be swapped together with this panel. For opening the
set, only remove the "smaller" part of the rear cover as
described below!
Warning!
The snaps on the backside of the LCD Panel secure the
backlight units and should never be released! Release
destroys the LCD Panel and voids warranty.
Refer to Figure 4-18 for details.
Warning: Disconnect the mains power cord before you remove
the rear cover.
Note: it is not necessary to remove the stand while removing
the rear cover.
Refer to Figure 4-9 for details.
Figure 4-9 Rear cover
1. Remove all screws of the rear cover; the part to be
removed [1] is indicated on
2. Lift the rear cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
4.5.2 Speakers
Tweeters
Each tweeter unit is mounted with one screw.
When defective, replace the whole unit.
Subwoofer
The central subwoofer is located in the centre of the set, behind
the stand and the -subframe, and is secured by two bosses.
Mechanical Instructions
1
18770_120_100212.eps
100216
Figure 4-9.
The stand and -subframe do not need to be removed for
removing the central subwoofer.
When defective, replace the whole unit.
4.5.3 Mains Switch
The mains switch is mounted on the front bezel with one screw.
4.5.4 Main Power Supply
Refer to Figure 4-10
2
1
2
2
Figure 4-10 Main Power Supply
Figure 4-11 Main Power Supply - back shielding
1. Unplug all connectors [1].
2. Remove the fixation screws [2].
3. Take the board out.
When defective, replace the whole unit.
When remounting, ensure that the back shielding plate is
positioned correctly.
back to
div. table
Q552.1E LA 4.
and Figure 4-11 for details.
2
1
2
18770_122_100212.eps
18770_123_100215.eps
EN 15
2
1
2
2
100216
100215
2010-Feb-19