Table of Contents
Advertisement
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
Put the cutlery in the cutlery basket with the sharp ends
•
pointing down or put them in the cutlery drawer in a horizontal
position with the sharp edges down.
Do not leave the appliance with the open door unattended to
•
avoid stepping accidentally onto it.
Before any maintenance operation, deactivate the appliance
•
and disconnect the mains plug from the socket.
Do not use high pressure water sprays and/or steam to clean
•
the appliance.
If the appliance has ventilation openings in the base, they must
•
not be covered e.g. by a carpet.
The appliance is to be connected to the water mains using the
•
new supplied hose-sets. Old hose sets must not be reused.
SAFETY INSTRUCTIONS
INSTALLATION
WARNING! Only a qualified person
must install this appliance.
•
Remove all the packaging.
•
Do not install or use a damaged appliance.
•
Do not use the appliance before installing it in
the built-in structure due to safety manner.
•
Follow the installation instructions supplied with
the appliance.
•
Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
•
Do not install or use the appliance where the
temperature is less than 0 °C.
•
Install the appliance in a safe and suitable place
that meets installation requirements.
ELECTRICAL CONNECTION
WARNING! Risk of fire and electric
shock.
•
The appliance must be earthed.
•
Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.
•
Always use a correctly installed shockproof
socket.
•
Do not use multi-plug adapters and extension
cables.
•
Make sure not to cause damage to the mains
plug and to the mains cable. Should the mains
cable need to be replaced, this must be carried
out by our Authorised Service Centre.
•
Connect the mains plug to the mains socket
only at the end of the installation. Make sure that
there is access to the mains plug after the
installation.
•
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
•
This appliance is fitted with a 13 A mains plug. If
it is necessary to change the mains plug fuse,
use only a 13 A ASTA (BS 1362) fuse (UK and
Ireland only).
WATER CONNECTION
•
Do not cause damage to the water hoses.
•
Before connection to new pipes, pipes not used
for a long time, where repair work has been
carried out or new devices fitted (water meters,
etc.), let the water flow until it is clean and clear.
•
Ensure that there are no visible water leaks
during and after the first use of the appliance.
•
If the water inlet hose is damaged, immediately
close the water tap and disconnect the mains
3
Hide quick links:
Advertisement
Table of Contents
