Skil 3410 Operating/Safety Instructions Manual page 14

3410 2610013681 ENG:2610008499 7/20/10 2:14 PM Page 14
ATTACHING THE GUARD ASSEMBLY
8. With one hand, hold the front of the barrier guard assembly
4 by the metal "fork." With the other hand, hold the guard
release lever 5 up (Fig. 10).
9. Lower the rear of guard assembly and slip the cross bar 6
into the rear notch 7 on top of the riving knife 2 (Fig. 10).
10. Lower the front of the guard assembly 4 until the metal "fork"
is parallel with the table (Fig. 11).
11. Press down on the guard release lever 5 until you feel and
hear it snap into the locking position. Check that the guard
assembly is securely connected (Fig. 11).
ATTACHING THE ANTI-KICKBACK DEVICE
12. Attach the Anti-Kickback Device 7 into the flat recessed
area 8 of the riving knife 2 (Fig. 12).
13. Squeeze the compression pads 9 while nesting the device
into the flat area (Fig. 12).
14. Release the compression pads such that the Anti-Kickback
Device locks onto the riving knife immediately behind the
guard assembly. Check that the attachment pin is securely
connected into locking hole. Carefully raise and lower the
pawls 10 – when letting go, the spring-loaded pawls must
come down and contact the table insert (Fig. 12).
Hint: Position the Anti-Kickback Device behind the flat recessed
area and slide it towards the front until it drops into the recessed
area – then release the compression pins.
Note: The two attachments are independant of each other, so
the Anti-Kickback Device can be attached before the Guard
Assembly.
ATTACHING THE OUTFEED ASSEMBLY
1. Attach the steel outfeed support 1 using the screws and
washers 2 (Fig. 13).
2. Tighten the screws using a Phillips screwdriver.
FIG. 13
1
FIG. 10
FIG. 11
FIG. 12
2
14.
4
5
4
5
7
9
9
8
2
7
6
2
10