Connection; Connection Via Nfc - Porsche 911 Speaker Operating Manual

Bluetooth

connection

®
1. Turn the 911 Speaker on using the power button .
button LED flashes in blue ].
2. Briefly press the Bluetooth ®
3. Activate the Bluetooth function on your source device.
®
4. Keep the Bluetooth ® button pressed down for around 2 seconds.
The LED will flash in white and you will hear the message 'Bluetooth
devices on your source device [ maximum reach 10 m ].
5. Look for nearby Bluetooth ®
6. Select '911 Speaker'.
7. When you are asked for a password, enter '0000' and confirm.
8. If your device is connected, the LED will light up in blue and you will hear the message 'Connected'.
9. The next time you switch on your 911 Speaker and activate the Bluetooth
the Bluetooth connection will occur automatically and you will hear the message 'Connected'.
®
Please note:
To connect additional Bluetooth ® -compatible source devices with your 911 Speaker, repeat steps 3–8. The 911 Speaker saves
the last 5 registered Bluetooth devices. Of these, a maximum of two [ not in True Wireless mode ] can be simultaneously connected with the
®
911 Speaker. This means that the use of a third source device is only possible once one of the already connected devices is disconnected.
The volume of the 911 Speaker is normally synchronised with that of your source device. However, the extent to which this works will depend
on your end device.
Betriebsanleitung_911_Speaker_420x148mm_EN.indd 10-11
Pairing'.
®
function on your source device,
®
Bluetooth

connection via NFC

®
If your Bluetooth -compatible audio playback device supports NFC technology, you can use this technology with the 911 Speaker as follows for an easier
®
connection:
1. Turn on the 911 Speaker using the power button .
2. Activate the Bluetooth and NFC functions on your audio playback device.
®
3. Press the Bluetooth button on the 911 Speaker [ LED flashes in blue ].
®
4. Place your source device with the NFC antenna on the NFC sensor of the 911 Speaker until a connection request is displayed.
5. Remove your Bluetooth device and confirm the connection request.
®
6. If you are asked for a password, enter the numbers '0000' and confirm.
7. If your device is connected, the LED will light up in blue and you will hear the message 'Connected'.
Please note: To disconnect the Bluetooth connection using NFC, place your audio playback device with the NFC aerial on the NFC sensor of the
®
911 Speaker until you hear 'Disconnected'. This function may not work properly depending on your audio playback device
Near-field communication
1. 2. 3.
[ EN ] The 911 Speaker
10 | 11
15.08.17 09:13