Table of Contents
Advertisement
Temporarily secure the drying-heater unit.
B
Attach the drying-heater unit to the arms and temporarily secure it using two bolts with attached
washers on both the right and left sides.
Washer
Bolt
Secure the drying-heater unit.
C
Raise up the drying-heater unit to eliminate any gap between the unit and the printer, then fully
tighten the four bolts.
Secure so there
are no gaps
Proceed to the next step according to the model you are using.
"Step 3: Installing the Blower-fan Unit" P. 10
"
Drying-
heater unit
Arm
2 locations
Secure so there
are no gaps
2 locations
Installing on the Printer
1. Introduction
9
Advertisement
Table of Contents
