Stop Lamp Switch (With Pedal Position Switch) - Suzuki SQ416 Service Manual

8E-22 CRUISE CONTROL SYSTEM
STOP LAMP SWITCH (WITH PEDAL POSITION
SWITCH)
INSPECTION
1) Disconnect negative (–) cable at battery.
2) Disconnect stop lamp switch connector and remove stop lamp
switch from pedal bracket.
3) Check switch (2 contacts) for resistance under each of the fol-
lowing each conditions.
If check result is not satisfactory, replace stop lamp switch.
Stop lamp switch specification
Between terminals "1" and "3" (Contact for stop lamp)
FREE (2): Continuity, PUSH (1): No continuity
Between terminals "2" and "4" (Contact for brake pedal
position)
FREE (2): No continuity, PUSH (1): Continuity
4) Install stop lamp switch and adjust its position referring to Sec-
tion 5.