Deck Lid Release Solenoid; Diagnosis And Testing - Deck Lid; Release; Removal - Chrysler 300M 2002 Service Manual

8N - 4

POWER LOCKS

POWER LOCKS (Continued)
Fig. 3 REMOTE KEYLESS ENTRY MODULE/BCM
1 - RKE ANTENNA CONNECTOR
2 - CONNECTORS
3 - RKE MODULE
4 - 20–WAY INTERNAL
HORN CHIRP TOGGLE
Once the transmitters have been programmed, the
horn chirp can be enabled/disabled by sending the
horn chirp toggle operation code to the Body Control
Module (BCM). This can be done using a DRB III
scan tool or by the customer. The horn chirp will
enter the opposite state of its current programmed
state by receiving this operation code. The BCM is
responsible for keeping track of the horn chirp sta-
tus.
DECK LID RELEASE
SOLENOID

DIAGNOSIS AND TESTING - DECK LID

RELEASE

For vehicles equipped with electric deck lid release.
(1) Confirm motor lead wire is connected and 10
volts or more are available at solenoid.
(2) Provide proper ground through latch mounting
screws.
(3) Remove latch and examine plunger. Plunger
should spring back when pressed.
(4) Insure that solenoid plunger travel is adequate
approximately 16 mm (5/8 inch).

REMOVAL

(1) Disconnect and isolate the negative battery
cable remote terminal from the remote battery post.
(2) Raise deck lid to the full up position.
(3) Remove latch cover attaching screws then
remove cover.
(4) Remove two mounting motor screws and
remote key cable retainers then remove motor.

INSTALLATION

(1) Install the two mounting motor screws and
remote key cable retainers and motor.
(2) Install the cover and latch cover attaching
screws.
(3) Connect and isolate the negative battery cable
remote terminal onto the remote battery post.
(4) Close the deck lid.
DECK LID RELEASE SWITCH
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Remove left lower instrument panel cover.
Refer to Body, Instrument Panel, Instrument Panel
and Pad Assembly, Removal and Installation.
(3) Pinch four tabs around side of decklid release
switch on the rear side of the left lower instrument
panel cover, and push switch through opening.
INSTALLATION
(1) push switch through opening and firmly snap
into place on the left lower instrument panel cover.
(2) Install the left lower instrument panel cover.
Refer to Body, Instrument Panel, Instrument Panel
and Pad Assembly, Removal and Installation.
(3) Connect the negative battery cable remote ter-
minal to the remote battery post.
DOOR CYLINDER LOCK
SWITCH
REMOVAL
(1) Open hood, disconnect and isolate the negative
battery cable remote terminal from the remote bat-
tery post.
(2) Refer to Body, Door - Front, for door trim and
water shield Removal.
(3) Disconnect the wiring clip and pigtail wire con-
nector (Fig. 4).
(4) Remove the Door Cylinder Lock Switch from
door lock cylinder.
LH