Sony CDP-XB630 Operating Instructions Manual page 5

Hookups
pWhen making analog hookups
When connecting an audio cord, be sure to match the
colour-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player
LINE OUT
L
R
You can adjust the output level to the amplifier
Press LINE OUT LEVEL +/– on the remote. You can
reduce the output level up to –20 dB.
When you reduce the output level, "FADE" appears in
the display.
When you turn off the player, the output level
automatically returns to the maximum level.
Note
If you press the LINE OUT LEVEL +/– buttons on the remote
while recording, the recording level will change even when it
is preset on the tape deck, etc.
pWhen making digital hookups
You can avoid deterioration of the signal during
transmission, since the music signal output through
the digital output connectors retains digital form.
You can connect a digital component such as a
digital amplifier, D/A converter, DAT or MD. When
you connect a DAT or MD, you can make digital
recordings from CDs.
Note that you cannot use the following functions
when making this connection:
• Fading in or out (see page 17)
• Time Fade (see page 17)
• Adjusting the output level using the LINE OUT
LEVEL +/– buttons on the remote (see above)
• If you have a digital component with an optical digital
input connector
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
CD player
DIGITAL OUT
COAXIAL OPTICAL
Amplifier
INPUT
CD
L
R
Digital component
DIGITAL IN
OPTICAL
• If you have a digital component with a coaxial digital
input connector (CDP-XB930 and CDP-XB930E only)
Connect the component via the DIGITAL OUT (COAXIAL)
connector using the coaxial cable (not supplied).
CD player
DIGITAL OUT
COAXIAL OPTICAL
Note
When you connect via the DIGITAL OUT connector, noise
may occur when you play CD software other than music, such
as a CD-ROM.
If you have a Sony component with the CONTROL
A1 (or CONTROL A1) jack
Connect the component via the CONTROL A1
You can simplify the operation of audio systems
composed of separate Sony components. For details, refer
to the supplementary "CONTROL-A1
instructions.
Connecting the mains lead
Connect the mains lead to a wall outlet.
Removing the warning from the disc tray
(CDP-XB930 and CDP-XB930E only)
The warning, "Do not touch the lens inside," is put
inside the disc tray at the factory.
Before using the player, you must remove this
warning. Turn on the player, and press
§ OPEN/CLOSE, and remove the warning.
Where do I go next?
Now you're ready to use your player.
If you aren't familiar with how to play CDs, go to the section
"Playing a CD" on page 6.
Then, go to the following sections for other operations.
Getting Started
Getting Started
Digital component
DIGITAL IN
COAXIAL
jack.
Control System"
GB
5