Sony 3-270-589-12 (1) Operating Instructions Manual page 98

TIME CODE [Time Code]: Settings related to the timecode
generator
VITC POS SEL-2 [> VITC pos-2]: Select a line to insert the
VITC in.
Note
You can insert the VITC signal in two places. To insert it in two
places, set both this item and VITC POS SEL-1.
EE OUT PHASE [> EE out]: Determine the output phase for
the LTC signal output from the TIME CODE OUT
connector when recording timecode and in STOP REC
mode (forced E-E mode).
SEARCH MUTING [> Srch muting]: Select whether to
suppress the output from the TIME CODE OUT connector
in search (jog/shuttle) mode.
PD PRESET [> PD preset]: Select the timecode to preset.
The A-frames of pulldown sequences are preset. (This
appears only when 24P (2-3 pulldown) is selected.)
VITC [> VITC]: Specifies whether or not to record VITC
generated by the internal timecode generator when
recording DVCAM-format signals.
DISC PROTECTION [Disc protct]: Settings related to disc
protection
STILL TIMER [>> STL timer]: Specify the length of time the
unit can be in still image mode before switching to disc
protection mode.
VIDEO CONTROL [Video]: Settings related to video
control
INT VIDEO SG [> Video
SG]: Select the test
signal to be output from
the internal test signal
generator. When you set
V INPUT in the HOME
page of the function
menu to "SG", the
internal signal generator
is activated and outputs
the selected test signal.
You can record this
signal.
98
System Menu
HD SIGNAL [>> HD Signal]:
Select the test signal for
HD output.
SD SIGNAL [>> SD Signal]:
Select the test signal for
SD output.
Description
When the system frequency is 60i, 23.98P or 30P
20LINE [>> 20 line] to 12LINE [>> 12 line]: Select any line
from 12 to 20.
Factory default setting: *18 LINE [>> 18 line] (line18)
Note
When the system frequency is 60i, 23.98P, or 30P, the VBID
(Video Blanking ID) receives priority over a selection of
"20LINE".
When the system frequency is 50i or 25P
22LINE [>> 22 line] to 9LINE [>> 9 line]: Select any line from
9 to 22.
Factory default setting: *21 LINE [>> 21 line] (line 21)
*MUTING [>> muting]: Suppress the output.
THROUGH [>> through]: Output the timecode input to the
TIME CODE IN connector as it is.
VIDEO INPUT PHASE [>> V input]: Output the timecode with
the same phase as the input video signal phase.
VIDEO OUTPUT PHASE [>> V output]: Output the timecode
with the same phase as the output video signal phase.
OFF [>> OFF] : Do not suppress.
*ON [>> ON]: Suppress.
24F TC [>> 24F TC]: Timecode value that becomes the
reference for A-frames.
30F TC [>> 30F TC]: Pulldown value with respect to the above
24-frame timecode.
OFF [>> OFF]: Do not record VITC.
*ON [>> ON]: Record VITC.
Description
0.5SEC [>>> 0.5 sec] to 30MIN [>>> 30 min]: Select time
from 16 settings ranging from 0.5 second to 30 minutes.
Factory default setting: *8MIN [>>> 8 min] (8 minutes)
Description
*100% COLOR BARS [>>> CB100]: 100% color bar signal
RAMP (Y/C) [>>> Ramp]: Bias signal
GRAY [>>> Gray]: Grayscale signal
BLACK [>>> Black]: Black signal
*100% COLOR BARS [>>> CB100]: 100% color bar signal
BLACK BURST [>>> BB]: Black burst signal