Raise And Lower The Roll Bar; Attaching A Trailer - Simplicity Cobalt Series Operator's Manual

21
4. Disengage the parking brake. The zero-turn rider can now
be pushed by hand.
5. After moving the zero-turn rider, close the bypass valves
by rotating the transmission release levers to the "run"
position (B). The transmission release levers will contact
the bodies of the transmissions. The transmission release
levers will be oriented so that they are parallel to the
axles of the transmissions.
Note: Both transmission release levers must be in the same
position.

Raise and Lower the Roll Bar

WARNING
Avoid serious injury or death from roll over:
• Keep roll bar in the raised position and use seat belt.
• There is no roll over protection when the roll bar is
down.
• Lower the roll bar only when necessary and NEVER
remove it.
• Do NOT use seat belt when the roll bar is down.
• Raise the roll bar as soon as clearance permits.
• Do NOT jump off if mower tips.
To lower the roll bar:
22
1. Pull the hair pin clips (A, Figure 22) out of the retainer
pins (B).
22
2. Push or pull the top of the roll bar (C) forward against the
spring clips (D) and remove the retainer pins (B).
3. Lower the roll bar and reinstall the retainer pins and hair
pin clips to secure the roll bar in the down position (see
insert, Figure 22).
To raise the roll bar:
1. Pull the hair pin clips (A) out of the retainer pins (B) and
remove the retainer pins.
2. Raise the roll bar (C) until the top of the roll bar (C)
contacts the spring clips (D) on the upright tubes.
3. Push or pull the top of the roll bar forward against the
spring clips and reinstall the retainer pins and hair pin
clips to secure the roll bar in the raised position.

Attaching a Trailer

The maximum weight of a towed trailer should be less than
200 lbs (91kg). Secure the trailer with an appropriately sized
clevis pin (A, Figure 23) and clip (B).
simplicitymfg.com