Skil RS582801 Owner's Manual page 12

To Attach/Detach Battery Pack
Lock the variable-speed trigger switch "OFF"
on the tool by depressing the lock-off button to
the locked position
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves on the tool, and then slide the battery
pack onto the tool (Fig.3).
To detach the battery pack:
Depress the battery-release button, located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool (Fig.3).
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack aligns with the groove inside the tool and
that the latches snap into place properly. Improper attachment of the battery pack can cause
damage to internal components.
WARNING
the tool is not in use or carrying it at your side .
Variable-Speed Trigger Switch
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the trigger.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure (Fig.4).
12
.
Battery tools are always in operating condition . Therefore, the lock-
off button should always be depressed in the locked position when
Fig. 3
Battery-
Release
Button
Fig. 4
Attach
Detach
Variable-Speed
Trigger Switch