Pump Control Wizard - Siemens SITRANS LUT400 Manual

Pump Control Wizard

The Pump Control Setup Wizard provides an easy step-by-step guide to help you
configure the pumps and relays for a simple application.
Pump Control Wizard steps
Notes:
• Complete the appropriate Quick Start Wizard (Level, Volume, or Volume
Linearization) prior to programming pump control.
• The Pump Control Setup Wizard settings are inter-related and changes apply only
after you click on Apply and Transfer at the end of the final step.
• Initial Pump Control Wizard parameter values are not default values and do not
necessarily reflect the current device configuration.
• Click on BACK to return and revise setting or Cancel to exit the Pump Control Wizard.
Launch SIMATIC PDM, open the menu Device – Wizard - Pump Control, and follow steps.
Step 1 – Application
1) Enable pump control, and select which relay is wired to Pump 1. (The relay for Pump
2 will be set automatically based on your selection for Pump 1.)
2. Click on Next.
Page 22 COMMUNICATIONS FOR SITRANS LUT400 (HART) – MANUAL A5E33701270