Subaru Legacy 2004 Service Manual page 358

COOLING
10) Connect the ATF cooler hoses. (Model without
ATF warmer)
11) Connect the radiator outlet hose.
12) Connect the connector (A) to radiator main fan
motor and connector (B) to sub fan motor.
(A)
Radiator
CO-00253
CO-00270
CO-00274
(B)
CO-00275
CO(H4SO 2.0)-22
13) Install the heat shield cover. (Model without
ATF warmer)
14) Install the under cover.
15) Lower the vehicle.
16) Connect the battery ground cable to battery.
17) Fill with engine coolant. <Ref. to CO(H4SO
2.0)-13, FILLING OF ENGINE COOLANT, RE-
PLACEMENT, Engine Coolant.>
18) Check the ATF level. <Ref. to 4AT-31, IN-
SPECTION, Automatic Transmission Fluid.>
C: INSPECTION
1) Remove the radiator cap, top off the radiator with
coolant, and then attach the tester in place of cap.
2) Apply a pressure of 157 kPa (1.6 kg/cm
to the radiator to check if:
• Engine coolant leaks at/around radiator.
• Engine coolant leaks at/around hoses or connec-
tions.
CAUTION:
• Engine should be turned off.
• Wipe engine coolant from check points in ad-
vance.
CO-00273
IN-00203
CO-00094
2
, 23 psi)