Subaru Legacy 2004 Service Manual page 296

MECHANICAL
NOTE:
Be careful not to confuse the original combination
of piston, piston pin and cylinder.
(5)
(1) Cylinder block
(2) Rear oil seal
35) Remove the rear oil seal.
36) Remove the crankshaft together with connect-
ing rod.
37) Remove the crankshaft bearings from cylinder
block using a hammer handle.
NOTE:
Be careful not to confuse the crankshaft bearing
combination. Press the bearing at the end opposite
to locking lip.
Cylinder Block
ST
ME-00142
(1)
(3)
(3) Crankshaft
(4) Crankshaft bearing
ME(H4SO 2.0)-66
30) Similarly remove the piston pins from #3 and #4
pistons.
31) Remove the bolts which connect cylinder block
on the side of #2 and #4 cylinders.
32) Back off the bolts which connect cylinder block
on the side of #1 and #3 cylinders two or three
turns.
33) Set up the cylinder block so that #1 and #3 cyl-
inders are on the upper side, then remove the cyl-
inder block connecting bolts.
34) Separate the cylinder block (RH) and (LH).
NOTE:
When separating the cylinder block, do not allow
the connecting rod to fall or damage the cylinder
block.
(4)
(2)
(4)
(1)
(5)
(5) Piston
38) Draw out each piston from cylinder block using
a wooden bar or hammer handle.
NOTE:
Be careful not to confuse the original combination
of piston and cylinder.
ME-00143