Samsung Freedom MIM-E03AN Installation And Maintenance Manual page 17

Heating & Hot Water, Pre-Plumbed Installation
Setting the Clock and Backlight
1. Press User Set once 1 shows on the screen.
2. Press up until 2 shows,
3. Press right twice, Year will show, use up to change year, press Set, 22 appears,
4. Press right Month will be flashing, adjust Month with up,
5. Press right, day will be flashing, adjust day with up,
Press Set. 22 shows, press up once, 23 shows,
6.
Press right, day and time are shown, day will be flashing, use up to adjust day,
7.
8. Press right, AM or PM will be flashing, use up to adjust AM, PM or both (24-hour clock),
9. Press right, hour will flash, press up to adjust hours,
10. Press right, minutes will flash, use up to adjust minutes,
11. Press Set.
12. 23 shows, Press left 2 flashes, press up twice 4 flashes,
13. Press right, 4 0511 shows, 05 flashes. This is the backlight time,
Press up until 30 flashes,
14.
Press Set, it will now stay on for 30 seconds,
15.
16. Press ESC to finish and return to normal screen.
Cylinder Timer
To avoid the cylinder heating being switched off accidentally we normally add 2 on timers a day, one at 3:00 am and one at 15:00 pm.
This stops nuisance tripping, resets the unit after power cuts and insures the cylinder is hot 24 hours a day. We don't normally set any off
times.
To set the cylinder up as above:
1. Press Timer button once,
2. Press right, daily is flashing, daily is the hot water time clock, press right
3. Press right 1 will show,
4. Press right,
5. On systems with a 12-hour clock, pm shows, press up till am and pm shows (24hours).
6. Press right, hours will be flashing, use up to set hours to 0300.
Press right, minutes will be flashing.
7.
Press right, ON will be flashing. *
8.
9. Press right, the tap will appear,
10. Press Set
You will return to 2 above. Now repeat with a timer at 15-00 hours.
You can delete or adjust timers by entering timer mode, press Timer once and scrolling up and down to the timer you want to adjust,
just keep scrolling right to the part you want to change and then use up down to adjust it, then press Set to store. To delete a timer
select it with up and down and press Delete, to save the changes made press the Set button. When you are finished press ESC.
Don't worry about the field settings, we have already had these done for you for use with your setup.
Installation Manual.indd 17
17
31/08/2018 19:01:25