Installation; Connections - Behringer EUROPOWER EP2500 User Manual

All manuals and user guides at all-guides.com
The BEHRINGER EUROLIVE SERIES loudspeakers are an
outstanding solution for expanding your P.A. system, because
each frequency range/application has a speaker type that
optimally suits its characteristics.
+
Fig. 3.7: Stereo bi-amp mode with a separate subwoofer
EUROPOWER EP1500/EP2500
Your EUROPOWER can be installed into a 19" rack and requires
two rack units. Please use four attaching screws and washers
for installation. Reinforce the back end, especially for on-the-
road use. Please assure that enough cool air reaches the rack,
especially when other rack equipment emanates a lot of heat. In
the case of the EUROPOWER EP1500 and EP2500, hot air
circulates at the front of the unit to thermally relieve the rack
enclosure.
+
Each channel features balanced XLR and 1/4" TRS stereo jack
inputs, with input impedances of 20 kΩ (balanced) and 10 kΩ
(unbalanced). In general, balanced signals cause less noise
than unbalanced signals.
For balanced input signals, use the XLR and 1/4" TRS stereo
inputs. For unbalanced input signals, use the unused pin of the
XLR connector with grounding. No alteration is necessary on
mono jack connectors (see plug type illustrations on page 10).
+
Your EUROPOWER offers several output connection possi-
bilities: two Neutrik NL4MD Speakon
of touch-safe binding posts. The Speakon
especially developed for driving high-power speakers. They snap
in securely, prevent electric shock and assure correct polarity.
The upper Speakon
and is therefore well-suited for mono-bridged operation (1+/2+).
The lower connector carries the signals from channel 2 only.
+

4. INSTALLATION

4. INSTALLATION

4.1 Connections

® connectors and two pairs
connectors were
®
connector drives either one or both channels,
®
Fig. 4.1: Speakon connectors
®
9