EUROPOWER EP1500/EP2500
When using binding post connectors, please make sure that
insulation on cables is not removed too high. Insert the naked
part of the cable fully so that no metal is visible. Cable clamps
must be isolated to avoid the possibility of electric shock. When
running the amp in mono-bridged mode, always use the middle
two binding post connectors, paying attention to correct polarity.
+
Always connect your EUROPOWER amplifier to the voltage
specified on the rear of the device. Connecting the amp to an
incorrect voltage can permanetly damage your amp.
Before powering up the amplifier, double-check all
connections and fully lower the gain setting.
4.2 Audio connections
Various cables are needed for different types of applications.
The following illustrations show the correct wiring. Always use
high-grade cables.
+
Fig. 4.2:
XLR connections
Fig. 4.3:
1/4" TS connector
10
All manuals and user guides at all-guides.com
4. INSTALLATION
Fig. 4.4: 1/4" TRS connector