Fortinet FortiController-5103B Session-Aware Load Balancer Manual page 8

Front panel LEDs and connectors
8
Table 2: FortiController-5103B LEDs (Continued)
LED State
Not used in the default configuration. See
SH1
LEDs" on page
Green or
Flashing
Green
SH2
Green
1 to 8 Flashing
Green
Off
Green
B1 and B2 Flashing
Green
Off
Link/Act Solid
(Left Green
LED)
Blinking
Green
MGMT
Off
Speed Green
(Right
Amber
LED)
Off
The unlabeled interface beside the MGMT interface is not used.
Blue
Flashing
IPM
Blue
Off
Description
9.
Network activity between the FortiController-5103B
board and one of the shelf managers across the chassis
backplane. If the FortiController-5103B board is installed
in chassis slot 1, this LED indicates a connection to shelf
manager 2. If the FortiController-5103B board is installed
in chassis slot 2, this LED indicates a connection to shelf
manager 1.
The correct cable is connected to the interface and the
connected equipment has power.
Network activity at the interface.
No link is established.
The correct cable is connected to the interface and the
connected equipment has power.
Network activity at the interface.
No link is established.
Indicates this interface is connected with the correct
cable and the attached network device has power.
Indicates network traffic on this interface.
No Link
Connection at 1 Gbps.
Connection at 100 Mbps.
Connection at 10 Mbps.
The FortiController-5103B is ready to be hot-swapped
(removed from the chassis). If the IPM light is blue and no
other LEDs are lit the FortiController-5103B board has
lost power
The FortiController-5103B is changing from hot swap to
running mode or from running mode to hot swap. This
happens when the FortiController-5103B board is starting
up or shutting down.
Normal operation. The FortiController-5103B board is in
contact with the chassis backplane.
FortiController-5103B Session-Aware Load Balancer Guide
FortiController-5103B system
"About the SH1 and SH2
10-500-161552-20140822
http://docs.fortinet.com/