Table of Contents
Advertisement
FortiController-5103B system
Front panel LEDs and connectors
LEDs
FortiController-5103B Session-Aware Load Balancer Guide
10-500-161552-20140822
http://docs.fortinet.com/
From the FortiController-5103B font panel you can view the status of the board LEDs to
verify that the board is functioning normally. You also connect the FortiController-5103B
board to your 10-gigabit network using the 1 to 8 front panel SFP+ connectors. The front
panel also includes B1 and B2 connectors for the base channels, an Ethernet
management interface (MGMT), an RJ-45 console port for connecting to the
FortiController-5103B CLI and a USB port. The USB port can be used with any USB key
for backing up and restoring configuration files.
FortiController-5103B front panel interfaces F1 to F8 appear on the
FortiController-5103B web-based manager and CLI as interfaces f1 to f8. In single
FortiController-5103B mode, workers see these as fctrl/1 to fctrl/8. In dual
FortiController-5103B mode, workers see these as fctrl1/1 to fctrl1/8 and fctrl2/1 to
fctrl2/8.
Table 2: FortiController-5103B LEDs
LED
State
Green
Fabric
(1/2 to 14)
Flashing
Green
Off
Green
Flashing
Base (1/2 to 14)
Green
Off
Off
OOS
Amber
(Out of Service)
PWR (Power)
Green
Off
Flashing
STA (Status)
Green
Off or
Flashing
green
ACC (Disk
activity)
Description
Fabric backplane interface is connected at 10 Gbps or 1
Gbps. Backplane Fabric interface slot-14 is not
accessible.
Network activity at the fabric backplane interface.
No link is established.
Base backplane interface is connected at 1 Gbps.
Network activity at the base backplane interface.
No link is established.
Normal operation.
A fault condition exists and the FortiController-5103B
blade is out of service (OOS). This LED may also flash
very briefly during normal startup.
The FortiController-5103B board is powered on.
The FortiController-5103B board is powered on.
The FortiController-5103B is starting up. If this LED is
flashing at any time other than system startup, a fault
condition may exist.
The ACC LED flashes green when the
FortiController-5103B board accesses the flash disk. The
flash disk stores the current firmware build and
configuration files. The system accesses the flash disk
when starting up, during a firmware upgrade, or when an
administrator is using the CLI or GUI to change the
FortiController-5103B configuration. Under normal
operating conditions this LED flashes occasionally, but is
mostly off.
Front panel LEDs and connectors
7
Advertisement
Table of Contents
