Korg Trinity Parameter Manual page 143

If you have connected a Korg PS-1 foot pedal, the polarity of the switch is ( ), so set this parame-
ter to "–". If you have connected a sustain pedal that has "+" polarity ( ), set this parameter to
"+". ( : Open type, : Closed type)
If the polarity setting does not match the sustain pedal that is connected, it will not function cor-
rectly.
If a sustain pedal is not connected, set this to "–".
1–1g: Effect Switch
Insert FX Off
If this is checked, all insert effects will be Off.
If this is un-checked, the On/Off setting of each insert effect will be determined by the On/Off
setting in Program Edit mode "7–1a: Insert Effect Setting" (
tion Edit mode "7–2a: Insert Effect Setting" (
Insert Effect Setting" (
When this is turned on/off, an Effect 2 Control message (CC#92) will be transmitted. The value
will be 127 when On, and 0 when Off.
Master FX [Mod] Off
If this is checked, [E1] (modulation-type master effect) will be Off.
If this is un-checked, the [E1] On/Off setting will be determined by the On/Off setting in Pro-
gram Edit mode, Combination Edit mode or Sequencer mode "8–1a: Effect 1/Effect 2 Setting" (
page 74 in this manual).
When this is turned on/off, an Effect 4 Control (CC#94) message will be transmitted. The value
will be 127 when On, and 0 when Off.
Master FX [R/D] Off
If this is checked, [E2] (reverb/delay-type master effect) will be Off.
If this is un-checked, the [E2] On/Off setting will be determined by the On/Off setting in Pro-
gram Edit mode, Combination Edit mode or Sequencer mode "8–1a: Effect 1/Effect 2 Setting" (
page 74 in this manual).
When this is turned on/off, an Effect 5 Control (CC#95) message will be transmitted. The value
will be 127 when On, and 0 when Off.
Page Menu Command
1–1A: Touch Panel Calibration
Use this command to make adjustments if touch panel input does not function the way that you
expect (for example if an on-screen control cannot be operated by touching the place where it is
displayed).
1 Touch the rectangle displayed at the upper left of the LCD screen.
When selected correctly, it will be displayed in inverse video.
Touch the rectangle displayed at the lower right of the LCD screen.
2
When selected correctly, it will be displayed in inverse video.
Press the Done button.
3
If calibration could not be performed correctly, an error message will appear. Try the operation
once again.
1–1B: Joystick X Calibration
Use this command if moving the joystick fully left or right does not produce the specified pitch
bend effect, or if the maximum or minimum effect is reached mid-way through the joystick's
travel.
1 Move the joystick fully left and then fully right as far as it will go.
Release the joystick.
2
Press the Done button.
3
If calibration could not be performed correctly, an error message will appear. Try the operation
once again.
1–1C: Enable Beep (Check Command)
If this is checked, pressing an active object on the LCD screen will produce sound.
page 71 in this manual) or Sequencer mode "7–3a:
page 123 in this manual).
1–1: Global Setup
page 48 in this manual), Combina-
135