About Bluetooth Icons; Connection; To Switch The Bluetooth Signal Output Of; This Unit To On - Sony MEX-BT2500 Operating Instructions Manual

4
Set the Bluetooth device to search for
this unit.
A list of detected devices appears in the
display of the connecting device. This unit is
displayed as "XPLOD" on the connecting
device.
5
If Passcode* input is required on the
display of a connecting device, input
"0000."
This unit and the Bluetooth device memorize
each other's information, and when pairing is
made, the unit is ready for connection to the
device.
" " flashes and then stays lit after pairing is
complete.
6
Set the Bluetooth device to connect to
this unit.
" " or " " appears when the connection is
made.
* Passcode may be called "passkey," "PIN code," "PIN
number" or "Password," etc., depending on the
device.
Note
Pairing standby mode is not released until the
connection is made.
12
DR-BT30Q
XPLOD
XXXXXXX
Input passcode.
"0000"
XXXX

About Bluetooth icons

The following icons are used by this unit.
lit: Bluetooth signal on
flashing: Pairing standby mode
off: Bluetooth signal off
lit: Connection successful
flashing: Connecting
off: No connection
lit: Connection successful
flashing: Connecting
off: No connection

Connection

If pairing has already been achieved, start
operation from here.
To switch the Bluetooth signal
output of this unit to on
To use the Bluetooth function, switch the
Bluetooth signal output of this unit to on.
1
While the unit is turned off, press and
hold (EQ/BLUETOOTH) until "
(about 3 seconds).
Bluetooth signal is switched to on.

Connecting a cellular phone

1
Be sure that both this unit and a
cellular phone are switched to
Bluetooth signal on.
2
Connect to this unit using your
cellular phone.
" "appears when the connection is made.
" lights