Technical Data; Installation - Electrolux GA55LI102 User Manual

Problem
How to activate the rinse aid dispenser
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press and hold function buttons B and C
until the indicator lights for function but-
tons A, B, and C start to flash.
4. Release function buttons B and C.
5. Press function button B.
– The indicator lights for function buttons
A and C go off.

Technical data

Dimensions
Water supply pressure
1)
Water supply
Capacity
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
The rating plate on the inner edge of the
appliance door shows the electrical con-
nection data.
If the hot water comes from alternative
sources of energy, (e.g. solar panels,

Installation

To attach the appliance to the adjacent
units
Make sure that the counter below which you
attach the appliance is attached to a safe
structure (adjacent kitchen units, cabinets,
wall).
1. Set the appliance in front of the kitchen
unit.
2. Put the mains cable and the hoses into
the recess unit.
3. Push the appliance in the recess unit. Do
not squash or bend the hoses and mains
cable.
4. Align the appliance and attach it on the
two sides in the upper area of the cabinet.
Possible cause
The multitab function is on. (The
rinse aid dispenser is automati-
cally off).
6. Press function button B again.
7. Switch off the appliance to keep the op-
Width
Height
Depth
Minimum
Maximum
Cold water or hot water
Place settings
Different procedures to attach the
appliance to the adjacent units
1. On the plinth.
Possible solution
Activate the rinse aid dispenser.
Refer to 'How to activate the
rinse aid dispenser'.
– The indicator light for function button B
continues to flash.
– The end-of-programme indicator light
comes on.
eration.
To deactivate the rinse aid dispenser, do
the same procedure until the end-of-
programme indicator light goes off.
photovoltaic panels and aeolian), use a
hot water supply to decrease energy
consumption.
electrolux 39
546 mm
759 mm
571 mm
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
maximum 60°C
11