Sony XDCAM EX PMW-EX1 Operating Instructions Manual page 107

OTHERS
Menu items Subitems and setting values Contents
Tally
Front
High / Low / Off
Setting the tally
lamps
Rear
On / Off
Hours Meter Hours (Sys)
Displaying the
Hours (Reset)
hours meter
Reset
Execute/Cancel
IR Remote On / Off
Activating/
deactivating the
Remote
Commander
Battery Alarm Low BATT
5% / 10% / 15% / ... / 45% /
Setting the low
50%
power alarm
BATT Empty
3% to 7% (3%)
DC Low Volt1
11.5 V to 17.0 V (11.5 V)
DC Low Volt2
11.0 V to 14.0 V (11.0 V)
Battery INFO
Type
Showing
MFG Date
information
Charge Count
regarding the
battery pack
Capacity
(display only)
Voltage
Remaining
Direct Menu All / Part / Off
Setting the Direct
menu function
i.LINK I/O Enable / Disable
Setting for input/
output at the
i.LINK connector
Set the brightness of the tally lamp on the front.
High: To brighten the lamp
Low: To dim the lamp
Off: To not light the lamp
Turn the tally lamp on the rear on/off.
The non-resettable accumulated time of use is displayed
The resettable accumulated time of use is displayed
Select "Execute" to reset the Hours (Reset) value to 0.
Set to "On" to activate remote control operations from the
supplied IR Remote Commander.
Note
The setting automatically returns to "Off" when the
camcorder is turned off.
Set the battery level at which the Low BATT warning is
generated (in steps of 5%).
Set the battery level at which the BATT Empty warning is
generated.
Set the DC IN voltage at which the DC Low Volt1 warning is
generated.
Set the DC IN voltage at which the DC Low Volt2 warning is
generated.
The type (product name) is displayed.
The date of manufacture is displayed.
The accumulated number of times of charge/discharge is
displayed.
The estimated total capacity of full charge is displayed.
The current output voltage is displayed.
The current remaining level is displayed.
All: All Direct menu operations are permitted.
Part: A part of Direct menu operations is permitted. The
operation is limited depending on the GAIN, SHUTTER,
or WHITE BAL switch setting.
Off: No Direct menu operation is permitted.
Enable: To use the i.LINK connector
Disable: To not use the i.LINK connector
Note
When you set this item to "Enable," no signal is fed out from
the SDI OUT connector.
Setup Menu List 107