Read This First - Sony HVR-Z1E/Z1P Operating Instructions Manual

Read this first

WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not open
the cabinet. Refer servicing to qualified
personnel only.
Notice
b
If static electricity or electromagnetic causes data
transfer to discontinue midway (fail), restart the
application or disconnect and connect the i.LINK
cable again.
FOR CUSTOMERS IN THE UNITED
KINGDOM
HVR-Z1E only
NOTICE ON THE SUPPLIED AC
ADAPTOR
A moulded plug complying with BS1363 is fitted to
this equipment for your safety and convenience.
Should the fuse in the plug supplied need to be
replaced, a fuse of the same rating as the supplied one
and approved by ASTA or BSI to BS1362 (i.e.,
marked with or
If the plug supplied with this equipment has a
detachable fuse cover, be sure to attach the fuse cover
after you change the fuse. Never use the plug without
the fuse cover. If you should lose the fuse cover, please
contact your nearest Sony service station.
FOR CUSTOMERS IN EUROPE
HVR-Z1E only
This product with the
with both the EMC Directive (89/336/EEC) and
the Low Voltage Directive (73/23/EEC) issued by
the Commission of the European Community.
Compliance with these directives implies
conformity to the following European standards:
• EN60065 : Product Safety (Supplied AC Adaptor
only)
2
mark) must be used.
marking complies
• EN55103-1 : Electromagnetic Interference
(Emission)
• EN55103-2 : Electromagnetic Susceptibility
(Immunity)
This product is intended for use in the following
Electromagnetic Environment(s):
E1 (residential), E2 (commercial and light
industrial), E3 (urban outdoors) and E4 (controlled
EMC environment ex. TV studio).
ATTENTION
The electromagnetic fields at the specific
frequencies may influence the picture and sound of
this camcorder.
This product has been tested and found compliant
with the limits set out in the EMC Directive for
using connection cables shorter than 1 meter (3.28
feet).
For the customers in the Nederland
Voor de klanten in Nederland
Dit apparaat bevat een vast ingebouwde batterij die
niet vervangen hoeft te worden tijdens de
levensduur van het apparaat.
Raadpleeg uw leverancier indien de batterij toch
vervangen moet worden.
De batterij mag alleen vervangen worden door
vakbekwaam servicepersoneel.
Gooi de batterij niet weg maar lever deze in als
klein chemisch afval (KCA).
Lever het apparaat aan het einde van de levensduur
in voor recycling, de batterij zal dan op correcte
wijze verwerkt worden.