Sony Handycam HDR-AX2000E Operating Manual page 36

Changing the settings of your camcorder recordings (Continued)
When the CH1 switch is set to
INT MIC
CH2 switch
Input channel and source
position
INT MIC Internal
microphone
(L)
Internal
microphone
(R)
INPUT1 Internal
microphone
(mono)
XLR INPUT1
INPUT2 Internal
microphone
(mono)
XLR INPUT2
When the CH1 is set to INPUT1
CH2 switch
Input channel and source
position
INT MIC XLR INPUT1
Internal
microphone
(mono)
INPUT1 XLR INPUT1
INPUT2 XLR INPUT1
XLR INPUT2
* The recording level of channel 2 is
synchronized with that of channel 1 when only
the internal microphone is used. The recording
level of channel 2 is controlled with the CH1
(AUDIO LEVEL) dial and the CH1 (AUTO/
MAN) switch.
** You can adjust the recording levels of channel 1
and channel 2 separately.
2 Set the INPUT1 switch B to an
appropriate position for the microphone
connected to the INPUT1 jack A.
36
LINE: For inputting sound from an
MIC: For inputting sound from an
MIC+48V:For inputting sound from a
CH1
When you connect a microphone to the
CH2*
INPUT2 jack, set the INPUT2 switch to
an appropriate position for that
microphone.
CH1
b Notes
• Do not operate the INPUT1/INPUT2 switches
CH2**
during recording to prevent noise from being
recorded.
CH1
• When you connect a device that supports the
+48V power source to the INPUT1 or INPUT2
jack, set the INPUT1/INPUT2 switches to MIC
CH2**
prior to connecting the device. When you
disconnect the device, set the INPUT1/INPUT2
switch to MIC first, then disconnect it.
• When you connect a microphone that does not
support the +48V power source to the INPUT1
or INPUT2 jack, set the INPUT1/INPUT2
CH1
switch to MIC. If you use it with the INPUT1/
INPUT2 switch set to MIC+48V, it may be
damaged or the recorded sound may be
CH2**
distorted.
CH1
Adjusting the volume
You can adjust the volume of an internal
CH2**
microphone or a microphone connected to
CH1
the INPUT1/INPUT2 jacks.
CH2**
z Tips
• See page 35 on the CH1 (INT MIC/INPUT1)
and the CH2 (INT MIC/INPUT1/INPUT2)
switches.
1 Set the AUTO/MAN (CH1/CH2) switch
E of the channel to be adjusted to
MAN.
2 Turn the AUDIO LEVEL dial F to
adjust the volume during recording or
standby.
audio device
external microphone that does
not support the +48V power
source.
device that supports the +48V
power source.
appears on the screen.